Quick Start Guide

This guide is intended to get you up and running quickly. Simply by following the 3 simple steps below; Attaching the emteqPRO mask your computer, run a demo application to save raw sensor data, and using out SuperVision monitoring application to view dara in real-time. If at any point you need assistance consult the more detailed manuals and our FAQ or contact our support team.

Tip

There are several ways to setup the mask and its associated software, in this first instance it is recommended to use the device in Open Face Mode, i.e not attached to a HTC Vive Pro. Also using one of our provided EmteqVR SDK Demo applications, rather than integrating straight into your own Unity Project.

1. Setting up the emteqPRO Mask

Once you receive you emteqPRO mask you can begin by selecting either the narrow or wide side pieces and insert them into the slots on the mask. You can see more detailed instructions here.

Once done you can use the provided USB cable to attach the emteqPRO mask to your computer. After a few seconds you should see a pop-up like this:

EmteqDAB Connected Message

Currently it is not required to pair the device via device.emteqlabs.com as the message suggests.
This will be a requirement as the beta program progresses.

2. Get our EmteqVR SDK Demo

To process and save DAB data from the emteqPRO mask you will need an application containing Core Services. In this example we will use the emteqvr-demos-desktop-X.Y.Z.zip.

Once you have downloaded the ZIP you can unpack it somewhere and run the emteqvr-demos-desktop-windows.exe to load the application. You may receive a warning confirming that you want to run the app under Windows 10.

Desk Demo App First Open

Note

You will see a mask indicator in the top right of the window with values rapidly updating, this means the mask is fully connected. However if these values are on 0 you may need to plug in the mask again or restart the application.

3. Viewing Real-Time Data via SuperVision

Lastly to view real time data as the mask is being used you can use our SuperVision app. Also found under the downloads page, or directly linked here.

Unpack this ZIP file and install the app, once installed it will run automatically. It will be kept updated whenever a new version becomes available.

When running both EmteqVR SDK and SuperVision on the same computer the default settings will allow a connection.

If you are using the applications on different computers on the same network you will need to update the IP settings in the SuperVision app. More detailed instructions can be found here.

Desk Demo App First Open